DiscImageChef Report for HL-DT-ST BD-RE GGW-H20L YL07

ATAPI characteristics:
ATAPI device
Model: HL-DT-ST BD-RE GGW-H20L
Firmware revision: YL07
Supported ATA versions: ATA/ATAPI-4 ATA/ATAPI-5 ATA/ATAPI-6 ATA/ATAPI-7
Maximum ATA revision supported: Minor ATA version not specified
Parallel ATA device:
Advanced PIO: PIO0 PIO1
Multi-word DMA: MDMA0 MDMA1 MDMA2
Ultra DMA: UDMA0 UDMA1 UDMA2 UDMA3 UDMA4 UDMA5 UDMA6 (active)

ATAPI CD-ROM/DVD/etc device
Device shall set DRQ within 50 µs of receiving PACKET
ATAPI device uses 12 byte command packet
Device capabilities:
IORDY is supported and can be disabled
DMA is supported
At minimum 120 ns. transfer cycle time per word in MDMA, 120 ns. recommended
At minimum 120 ns. transfer cycle time per word in PIO, without flow control
At minimum 120 ns. transfer cycle time per word in PIO, with IORDY flow control
Command set and features:
NOP is supported and enabled
DEVICE RESET is supported and enabled
PACKET is supported and enabled
Power management is supported and enabled
28-bit LBA is supported

SCSI characteristics:
Vendor: HL-DT-ST (Hitachi-LG Data Storage, Inc.)
Product: BD-RE GGW-H20L
Revision: YL07
Device is connected and supported.
CD-ROM/DVD/etc device
Device claims to comply with ANSI X3.408:2005 (SPC-3)
Device does not claim to comply with any SCSI ECMA standard
Device does not claim to comply with any SCSI ISO/IEC standard
Device is removable
Device supports setting Normal ACA
Device supports LUN hierarchical addressing
Device does not support assymetrical access
Device supports only ST clocking
Device supports MODE SENSE (10)
Device supports MODE SENSE subpages

SCSI mode sense pages:
Mode Contents
MODE page 01h SCSI Read error recovery page for MultiMedia Devices:
Drive will repeat read operations 19 times
Unknown recovery parameter 0x80
Drive will repeat write operations 3 times
MODE page 05h SCSI Flexible disk page:
Transfer rate: 24581 kbit/s
8 heads
0 cylinders
16 sectors per track
0 bytes per sector
Drive steps in 15000 μs
Target shall wait 0 seconds before attempting to access the medium after motor on is asserted
Target shall wait 0 seconds before releasing the motor on signal after becoming idle
Drive needs to do 1 step pulses per cylinder
Pin 34 is unconnected
Pin 4 is unconnected
Pin 2 is unconnected
Pin 1 is unconnected
MODE page 08h SCSI Caching mode page:
Write-cache is enabled
Drive does not distinguish between cached read data
Drive does not distinguish between cached write data
Pre-fetch will be done for READ commands of 2048 blocks or less
A maximum of 128 blocks will be pre-fetched
A maximum of 128 blocks will be pre-fetched even if it is commanded to pre-fetch more
MODE page 0Dh SCSI CD-ROM parameters page:
Drive will remain in track hold state 2 minutes after a seek or read
Each minute has 60 seconds
Each second has 75 frames
MODE page 18h Unknown mode page
MODE page 1Ah SCSI Power condition page:
Standby timer Z is set to 120000 ms
Idle timer A is set to 60000 ms
MODE page 1Ch SCSI Timer & Protect page:
Drive will remain in same status 1 second after a seek, read or write operation
MODE page 1Dh Undecoded
MODE page 20h Unknown mode page
MODE page 2Ah SCSI CD-ROM capabilities page:
Drive can read sectors in Mode 2 Form 1 format
Drive can read sectors in Mode 2 Form 2 format
Drive supports multi-session discs and/or Photo-CD
Drive can read digital audio
Drive can continue from streaming loss
Drive supports C2 pointers
Drive can read Media Catalogue Number
Drive can read ISRC
Drive uses a tray
Drive can lock media
Drive is not locked, media can be ejected and inserted
Drive can eject media
Drive has 2048 Kbyte of buffer
Drive's maximum reading speed is 7056 Kbyte/sec.
Drive's current reading speed is 7056 Kbyte/sec.
Drive can read and write CD-R
Drive supports reading CD-R packet media
Drive can read and write CD-RW
Drive can read DVD-ROM
Drive can read and write DVD-R
Drive can read and write DVD-RAM
Drive's current writing speed is 7056 Kbyte/sec. in CLV mode
Drive supports writing at 7056 Kbyte/sec. in CLV mode
Drive supports writing at 5645 Kbyte/sec. in CLV mode
Drive supports writing at 4234 Kbyte/sec. in CLV mode
Drive supports writing at 2822 Kbyte/sec. in CLV mode
Drive supports writing at 1411 Kbyte/sec. in CLV mode
Drive supports writing at 706 Kbyte/sec. in CLV mode
Drive supports test writing
Drive can read both sides of a disc
Drive an read raw R-W subchannel from the Lead-In
Drive supports DVD CSS and/or DVD CPPM
Drive supports buffer under-run free recording
MODE page 31h Unknown mode page
MODE page 32h Unknown mode page

SCSI CD-ROM capabilities:
Drive an read raw R-W subchannel from the Lead-In
Drive can continue from streaming loss
Drive can eject media
Drive can lock media
Drive can read and write CD-R
Drive can read and write CD-RW
Drive can read and write DVD-R
Drive can read and write DVD-RAM
Drive can read both sides of a disc
Drive can read digital audio
Drive can read DVD-ROM
Drive can read ISRC
Drive can read Media Catalogue Number
Drive can read sectors in Mode 2 Form 1 format
Drive can read sectors in Mode 2 Form 2 format
Drive has 2048 Kbyte of buffer
Drive is not locked, media can be ejected and inserted
Drive supports buffer under-run free recording
Drive supports C2 pointers
Drive supports DVD CSS and/or DVD CPPM
Drive supports multi-session discs and/or Photo-CD
Drive supports reading CD-R packet media
Drive supports test writing
Drive supports writing at 1411 Kbyte/sec. in CLV mode
Drive supports writing at 2822 Kbyte/sec. in CLV mode
Drive supports writing at 4234 Kbyte/sec. in CLV mode
Drive supports writing at 5645 Kbyte/sec. in CLV mode
Drive supports writing at 7056 Kbyte/sec. in CLV mode
Drive supports writing at 706 Kbyte/sec. in CLV mode
Drive uses a tray
Drive's current reading speed is 7056 Kbyte/sec.
Drive's current writing speed is 7056 Kbyte/sec. in CLV mode
Drive's maximum reading speed is 7056 Kbyte/sec.


SCSI MMC features:
2048 bytes per logical block
4 media blocks are required for the binding nonce
Drive can do a test writing in Session at Once Mode
Drive can do a test writing in Track at Once Mode
Drive can do a test writing with DVDs
Drive can eject media
Drive can format media into logical blocks
Drive can lock media
Drive can overwrite a SAO track with another in CD-RWs
Drive can overwrite a TAO track with another in CD-RWs
Drive can read and write DVD+R
Drive can read and write DVD+R DL
Drive can read and write DVD+RW
Drive can read BD-ROM
Drive can read CD-ROM
Drive can read DVD
Drive can read HD DVD-ROM, HD DVD-RW and HD DVD-R
Drive can return CD-Text from Lead-In
Drive can return Spare Area Information
Drive can write BD-R on Pseudo-OVerwrite SRM mode
Drive can write BD-R or BD-RE
Drive can write CD-RW
Drive can write CDs in Session at Once and in Raw Modes:
Drive can write CDs in Track at Once Mode:
Drive can write user provided data in the R-W subchannels in Session at Once Mode
Drive claims capability to read all CD formats according to OSTA Multi-Read Specification
Drive firmware is dated 03/19/2011 00:00:00
Drive is able to access Hybrid discs
Drive is to report drive serial number
Drive shall report Read/Write Error Recovery mode page
Drive supports 1 AGIDs concurrently
Drive supports AACS version 1
Drive supports C2 Error Pointers
Drive supports Device Busy events
Drive supports DVD CPPM version 1
Drive supports DVD CSS/CPPM version 1
Drive supports generating the binding nonce
Drive supports Microcode Upgrade
Drive supports set/release of PWP status
Drive supports the Informational Exceptions Control mode page 1Ch
Drive supports writing DVD-R, DVD-RW and DVD-R DL
Drive supports zero loss linking in Session at Once Mode
Drive supports zero loss linking in Track at Once Mode
Drive supports zero loss linking writing DVDs
Drive uses a tray
Drive uses Serial ATAPI interface