DiscImageChef Report for FUJITSU MAN3367M SUN36G 1502

SCSI characteristics:
Vendor: FUJITSU (Fujitsu)
Product: MAN3367M SUN36G
Revision: 1502
Device is connected and supported.
Direct-access device
Device claims to comply with ANSI X3.131:1994 (SCSI-2)
Device does not claim to comply with any SCSI ECMA standard
Device does not claim to comply with any SCSI ISO/IEC standard
Device supports 16-bit wide SCSI addresses
Device supports 16-bit wide data transfers
Device supports synchronous data transfer
Device supports linked commands
Device supports TCQ queue
Device does not support assymetrical access
Device supports only ST clocking
Device supports MODE SENSE (6)
Device supports MODE SENSE (10)

Device has 71132959 blocks of 512 bytes each
Device size: 36420075008 bytes, 36 Gb, 33.92 GiB
Medium type code: 00h
Long block size: 576 bytes
Device supports READ CAPACITY (10) command.
Device supports READ (6) command.
Device supports READ (10) command.
Device supports READ LONG (10) command.

SCSI mode sense pages:
Mode Contents
MODE page 01h SCSI Read-write error recovery page:
Parameters can be saved
Automatic write reallocation is enabled
Automatic read reallocation is enabled
Data not recovered within limits shall be transferred back before a CHECK CONDITION
Drive will use the most expedient form of error recovery first
Drive shall report recovered errors
Drive will repeat read operations 63 times
Drive will repeat write operations 63 times
Drive will employ a maximum of 15000 ms to recover data
MODE page 02h SCSI Disconnect-Reconnect mode page:
Parameters can be saved
100 µs maximum permitted to assert BSY without a REQ/ACK handshake
Data transfer disconnect control is not used
MODE page 03h SCSI Format device page:
Parameters can be saved
27 tracks per zone to use in dividing the capacity for the purpose of allocating alternate sectors
24 sectors per zone that shall be reserved for defect handling
0 tracks per zone that shall be reserved for defect handling
27 tracks per LUN that shall be reserved for defect handling
107 physical sectors per track
512 Bytes per physical sector
Target-dependent interleave value is 1
88 sectors between last block of one track and first block of the next
82 sectors between last block of a cylinder and first block of the next one
Drive supports hard-sectoring format
Sector addressing is progressively incremented in one cylinder before going to the next
MODE page 04h SCSI Rigid disk drive geometry page:
Parameters can be saved
27 heads
24622 cylinders
Write pre-compensation starts at cylinder 0
Write current reduction starts at cylinder 0
Heads park in cylinder 0
Medium rotates at 10025 rpm
Spindle synchronization is disable or unsupported
MODE page 07h SCSI Verify error recovery page:
Parameters can be saved
Drive will use the most expedient form of error recovery first
Drive will repeat verify operations 63 times
Drive will employ a maximum of 15000 ms to recover data
MODE page 08h SCSI Caching mode page:
Parameters can be saved
Drive does not distinguish between cached read data
Drive does not distinguish between cached write data
Pre-fetch will be done for READ commands of 65535 blocks or less
A maximum of 65535 blocks will be pre-fetched even if it is commanded to pre-fetch more
Drive should not reorder the sequence of write commands to be faster
Drive should have 8 cache segments
MODE page 0Ah SCSI Control mode page:
Parameters can be saved
The logical unit maintains one task set for all nexuses
Commands can be reordered in any manner
If ACA is established, the task set commands shall resume after it is cleared, otherwise they shall terminate with CHECK CONDITION
LUN shall clear unit attention condition reported in the same nexus
On medium insertion, it shall be loaded for full access
A maximum of 176100 ms are allowed to remain busy
MODE page 0Ch Unknown mode page
MODE page 1Ch SCSI Informational exceptions control page:
Parameters can be saved
Informational exceptions are enabled
Unconditionally generate recovered error on informational exceptions
Drive shall log informational exception conditions
Informational exception conditions will be reported a maximum of 1 times
MODE page 21h Unknown mode page

SCSI extended vital product data pages:
EVPD Contents
EVPD page 00h Undecoded
EVPD page C0h Undecoded
EVPD page C1h Undecoded